Table of Contents
Advertisement
Chapter 14: Secure Mobility® MatriX
Mark the Acquire a snapshot from the master? checkbox to configure the Replication
5.
Node to upload the database snapshot file that is generated on the Replication
Master. The upload occurs when you restart the Replication Nodes, later in this
procedure.
Click Save to store the information to the BSC database.
6.
Step 4: Set Up Cascaded Replication (More than Ten BSCs)
Version 4 and later of the BSC system software supports a cascaded replication
configuration as shown in Figure 14-10. In the cascaded configuration, a BSC that is
configured to act as a Replication Node for a Replication Master is also configured to act
as a Replication Master for other Replication Nodes. We recommend that you use a
cascaded replication configuration for networks of more than ten BSCs (your network
should be configured such that no more than ten BSCs receive their configurations from
the same Replication Master).
To reconfigure a Node as a combination Replication Master/Node:
Click the Mobility MatriX tab in the BSC administrator console, and then click the
1.
Replication Setup tab as shown in Figure 14-14.
Mark the Act as a master and transmit configuration settings to the replication nodes?
2.
checkbox.
3.
Do not modify any of the existing Replication Node settings.
Click Save to save the BSC Replication settings to the BSC database.
4.
Set up the list of nodes that should receive their settings from this combination
5.
Replication Master/Node, as explained in "Step 2: Create a List of Replication
Nodes on Master" on page 14-12.
14-14
Figure 14-13: Configuring Replication on a Node BSC
Advertisement
Table of Contents
