Table of Contents
Advertisement
Chapter 12: BlueSecure Access Points
Display
Specify which login page to display to users logging into the BSC on the managed
interface via this BSAP from the drop-down menu. Select Normal to use the location- or
VLAN-based login page or select a customized page you have defined. See
"Customizing the User Login Page" on page 11-2 for information about creating a
customized user login page.
Diagnostics
Mark the Allow remote diagnostics checkbox to allow Bluesocket service personnel to
reach the BSAP via SSH to perform remote diagnostics (Optional – this only applies to the
BSAP-15x0 platform).
Saving the
Click Save to save the BSAP settings to the BSC database.
settings
You may be prompted to restart the BSC. We recommend that you do not restart the BSC
until you have completely finished configuring the BSC for use in your network.
Enabling BSAP Service
You must enable BSAP service to allow BSAPs to communicate with the BSC over a secure
connection for management purposes.
To enable BSAP service:
Displaying the
Click the Wireless tab in the BSC administrator console, and then click the Service tab.
AP Service page
The AP Service page appears as shown in Figure 12-11.
Enable AP
The Enable AP Service checkbox is marked by default to enable the BSC to communicate
Service
with and manage BSAPs over a secure connection.
Role applied to
Select the role from the drop-down. This role will be automatically applied to connected
connected APs
APs. If services are required, the role will automatically be adjusted.
Allow new
Specify what BSAPs are allowed to connect to the BSC by selecting one of the following
connections
options from the drop-down menu:
from
•
None - BSAPs are unable to connect to the BSC. You must change this setting to one
of the two options listed below to enable the BSC to manage BSAPs.
12-26
Figure 12-11: Enable BSAP Service Page
Advertisement
Table of Contents
