Voip Protocols/Vowlan Support; Secure Mobility® Matrix; The Bluesecure Wlan Solution End-User Experience; Transparent Authentication - ADTRAN BlueSecure Controller Setup And Administration Manual

VoIP Protocols/VoWLAN Support

You can configure the BSC to support Voice-over-WLAN (VoWLAN) phones by enabling
VoIP protocols such as H.323, Session Initiation Protocol (SIP), and Cisco Signaling
Connection Control Part (SCCP) for stateful inspection by the BSC. Additionally, you can
configure vendor-specific IP phones (Polycom, Cisco, Skype, and Vocera), and system-
level QoS for voice traffic.
Secure Mobility
Where multiple BlueSecure Controllers are deployed across multiple WLANs, Bluesocket
provides centralized management and control through its Secure Mobility MatriX
architecture, as illustrated in the following figure.
The BlueSecure Controllers comprising the MatriX communicate with each other in real
time enabling seamless secure roaming, policy enforcement, configuration replication,
load sharing, and high availability.

The BlueSecure WLAN Solution End-user Experience

As with the introduction of any new technology to your network, it is important to
understand how the end-user population uses and experiences the technology. The end-
user experience of the BlueSecure Controller WLAN solution largely depends on the
authentication method(s) you enable, seamless secure roaming across multiple WLAN
and the reliable, low latency RF environment supported by the BlueSecure Access Points.
The BlueSecure Controller can support multiple authentication methods simultaneously.

Transparent Authentication

With some authentication methods the BlueSecure Controller is transparent to the user.
These methods include transparent NTLM, transparent 802.1x, and MAC-based
authentication.
A transparent domain authentication means that the wireless user authentication process
is no different than that on a wired user. The BlueSecure Controller is intelligent and
identifies users who are trying to log into the domain and dynamically communicates with
the domain controllers defined in the Bluesocket BSC configuration.
If successful, the user is not only logged into the domain but is also placed into a role in
the BlueSecure Controller based on which domain controller the user authenticated
against, or some user attribute returned by Active Directory.
BlueSecure™ Controller Setup and Administration Guide
The BlueSecure WLAN Solution End-user Experience
®
MatriX

Figure 1-2: The Bluesocket Secure Mobility MatriX Architecture

1-5