Ssid Configuration Procedure; Figure 12-9: Create New Ssid Page - ADTRAN BlueSecure Controller Setup And Administration Manual

Chapter 12: BlueSecure Access Points
TKIP (This option cannot be used with 802.11n when connecting at rates above 54Mhz).
Temporal Key Integrity Protocol (TKIP): WPA specifies the TKIP data encryption method to
replace WEP. TKIP avoids the problems of WEP static keys by dynamically changing data
encryption keys. TKIP starts with a master (temporal) key for each user session and then
mathematically generates other keys to encrypt each data packet. TKIP provides further
data encryption enhancements by including a message integrity check for each packet
and a re-keying mechanism, which periodically changes the master key.

SSID Configuration Procedure

To create an SSID for assignment to a BSAP:
Displaying the 1. Click the Wireless tab, click the SSID tab, and then select SSID from the Create drop-
Create new down menu. The Create new SSID page appears as shown in Figure 12-9.
SSID page
Enable by The Enable by default on the b/g/n radio checkbox is marked by default to enable this
default... SSID for radio b/g/n.
The Enable by default on the a radio checkbox is marked by default to enable this SSID
for radio a.
General Settings • Name - The name of the SSID. This is useful for mapping the same SSID to different
configurations and APs. The name must be unique.
• SSID -- Enter the Service Set Identifier that all wireless clients must use to associate
with the BSAP.
12-22

Figure 12-9: Create new SSID Page