Set System Contact; Set Width - Enterasys D2 D2G124-12P Cli Reference Manual

set system contact

set system contact
Use this command to identify a contact person for the system.
Syntax
set system contact [string]
Parameters
string
Defaults
If string is not specified, the contact name will be cleared.
Mode
Switch command, read‐write.
Example
This example shows how to set the system contact string:
D2(su)->set system contact "Joe Smith"

set width

Use this command to set the number of columns for the terminal connected to the switch's console
port.
Syntax
set width screenwidth [default]
Parameters
screenwidth
default
Defaults
None.
Mode
Switch command, read‐write.
Usage
The number of rows of CLI output displayed is set using the set length command as described in
"set length" on page 2‐25.
2-24 Basic Configuration
(Optional) Specifies a text string that contains the name of the person to
contact for system administration.
Note: A contact string containing a space in the text must be enclosed
in quotes as shown in the example below.
Sets the number of terminal columns. Valid values are 50 to 150.
(Optional) Makes this setting persistent for all future sessions (written to
NV‐RAM).