Configuring Igmp At Layer 2; Purpose; Commands; Show Igmpsnooping - Enterasys D2 D2G124-12P Cli Reference Manual

Configuring IGMP at Layer 2

multicast switch/router it passes through to ensure that traffic is only passed to the hosts that
subscribed to this service.
Configuring IGMP at Layer 2

Purpose

To configure IGMP snooping from the switch CLI.

Commands

For information about...

show igmpsnooping

set igmpsnooping adminmode
set igmpsnooping interfacemode
set igmpsnooping groupmembershipinterval
set igmpsnooping maxresponse
set igmpsnooping mcrtrexpiretime
set igmpsnooping add-static
set igmpsnooping remove-static
show igmpsnooping static
show igmpsnooping mfdb
clear igmpsnooping
show igmpsnooping
Use this command to display IGMP snooping information.
Syntax
show igmpsnooping
Parameters
None.
Defaults
None.
Mode
Switch command, read‐only.
11-2 IGMP Configuration
Refer to page...
11-2
11-3
11-4
11-4
11-5
11-5
11-6
11-7
11-7
11-8
11-8