Enterasys D2 D2G124-12P Cli Reference Manual page 31

Table 1-1 Default Settings for Basic Switch Operation (Continued)
Feature
Link aggregation flow
regeneration
Link aggregation system
priority
Link aggregation outport
algorithm
Lockout
Logging
MAC aging time
MAC locking
Passwords
Password aging
Password history
Policy classification
Port auto-negotiation
Port advertised ability
Port broadcast suppression Enabled and set to limit broadcast packets to 14,881 per second on all switch
Port duplex mode
Port enable/disable
Port priority
Port speed
Port trap
Power over Ethernet port
admin state
Priority classification
RADIUS client
RADIUS last resort action
RADIUS retries
RADIUS timeout
Rate limiting
SNMP
SNTP
Spanning Tree
Default Setting
Disabled.
Set to 32768 for all ports.
Set to DIP-SIP.
Set to disable Read-Write and Read-Only users, and to lockout the default
admin (Super User) account for 15 minutes, after 3 failed login attempts.
Syslog port set to UDP port number 514. Logging severity level set to 6
(significant conditions) for all applications.
Set to 300 seconds.
Disabled (globally and on all ports).
Set to an empty string for all default user accounts. User must press ENTER
at the password prompt to access CLI.
Disabled.
No passwords are checked for duplication.
Classification rules are automatically enabled when created.
Enabled on all ports.
Maximum ability advertised on all ports.
ports.
Set to half duplex, except for 100BASE-FX and 1000BASE-X, which is set to
full duplex.
Enabled.
Set to 0.
Set to 10 Mbps, except for 1000BASE-X, which is set to 1000 Mbps, and
100BASE-FX, which is set to 100 Mbps.
All ports are enabled to send link traps.
Administrative state is on (auto).
Classification rules are automatically enabled when created.
Disabled.
When the client is enabled, set to Challenge.
When the client is enabled, set to 3.
When the client is enabled, set to 20 seconds.
Disabled (globally and on all ports).
Enabled.
Disabled.
Globally enabled and enabled on all ports.
Factory Default Settings
D-Series CLI Reference 1-3