Ping; Show Users - Enterasys D2 D2G124-12P Cli Reference Manual

Mode
Switch command, read‐write.
Example
This example shows how to set the size of the command history buffer to 30 lines:
D2(su)->set history 30

ping

Use this command to send ICMP echo‐request packets to another node on the network from the
switch CLI.
Syntax
ping host
Parameters
host
Defaults
None.
Mode
Switch command, read‐write.
Examples
This example shows how to ping IP address 134.141.89.29. In this case, this host is alive:
D2(su)->ping 134.141.89.29
134.141.89.29 is alive
In this example, the host at IP address is not responding:
D2(su)->ping 134.141.89.255
no answer from 134.141.89.255

show users

Use this command to display information about the active console port or Telnet session(s) logged
in to the switch.
Syntax
show users
Parameters
None.
Defaults
None.
Specifies the IP address of the device to which the ping will be sent.
ping
D-Series CLI Reference 12-13