Port Configuration Summary; Port String Syntax Used In The Cli - Enterasys D2 D2G124-12P Cli Reference Manual

This chapter describes the Port Configuration set of commands and how to use them.
For information about...

Port Configuration Summary

Reviewing Port Status
Disabling / Enabling and Naming Ports
Setting Speed and Duplex Mode
Enabling / Disabling Jumbo Frame Support
Setting Auto-Negotiation and Advertised Ability
Setting Flow Control
Setting Port Link Traps and Link Flap Detection
Configuring Broadcast Suppression
Port Mirroring
Link Aggregation Control Protocol (LACP)
Configuring Protected Ports
Port Configuration Summary

Port String Syntax Used in the CLI

Commands requiring a port‐string parameter use the following syntax to designate port type, slot
location, and port number:
port type.unit number.port number
Where port type can be:
ge for 1‐Gbps Ethernet
host for the host port
vlan for vlan interfaces
lag for IEEE802.3 link aggregation ports
Where unit number is 1 for the D2 standalone unit, and
Port number can be:
1 – 12 for the D2G124‐12 and the D2G124‐12P
The highest valid port number is dependent on the number of ports in the device and the port
type.
Port Configuration
Refer to page...
D-Series CLI Reference 4-1
4
4-1
4-3
4-7
4-9
4-12
4-14
4-18
4-19
4-28
4-31
4-33
4-47