Set Port Negotiation; Show Port Advertise - Enterasys D2 D2G124-12P Cli Reference Manual

Parameters
port‐string
Defaults
If port‐string is not specified, auto‐negotiation status for all ports will be displayed.
Mode
Switch command, read‐only.
Example
This example shows how to display auto‐negotiation status for 1‐Gigabit Ethernet port 14 in slot 3:
D2(su)->show port negotiation ge.3.14
auto-negotiation is enabled on port ge.3.14.

set port negotiation

Use this command to enable or disable auto‐negotiation on one or more ports.
Syntax
set port negotiation port-string {enable | disable}
Parameters
port‐string
enable | disable
Defaults
None.
Mode
Switch command, read‐write.
Example
This example shows how to disable auto‐negotiation on 1‐Gigabit Ethernet port 3 in slot 14:
D2(su)->set port negotiation ge.3.14 disable

show port advertise

Use this command to display port capability and advertisement as far as speed and duplex for
auto‐negotiation.
Syntax
show port advertise [port-string]
(Optional) Displays auto‐negotiation status for specific port(s). For a
detailed description of possible port‐string values, refer to "Port String
Syntax Used in the CLI" on page 4‐1.
Specifies the port(s) for which to enable or disable auto‐negotiation. For a
detailed description of possible port‐string values, refer to "Port String
Syntax Used in the CLI" on page 4‐1.
Enables or disables auto‐negotiation.
set port negotiation
D-Series CLI Reference 4-15