Show Rmon Channel; Set Rmon Channel - Enterasys D2 D2G124-12P Cli Reference Manual

show rmon channel

show rmon channel
Use this command to display RMON channel entries for one or more ports.
Syntax
show rmon channel [port-string]
Parameters
port‐string
Defaults
If port‐string is not specified, information about all channels will be displayed.
Mode
Switch command, read‐only.
Example
This example shows how to display RMON channel information for
D2(rw)->show rmon channel ge.2.12
Port ge.2.12
----------------------------------------------------------
Control
OnEventIndex
EventIndex
Matches
Description
Owner

set rmon channel

Use this command to configure an RMON channel entry.
Syntax
set rmon channel index port-string [accept {matched | failed}] [control {on | off}]
[description description] [owner owner]
Parameters
index
port‐string
accept matched |
failed
control on | off
13-16 RMON Configuration
(Optional) Displays RMON channel entries for a specific port(s).
Channel index= 628
off AcceptType
0 OffEventIndex
0 Status
4498
Thu Dec 16 12:57:32 EST 2004
NetSight smith
Specifies an index number for this entry. An entry will automatically be
created if an unused index number is chosen. Maximum number of
entries is 2. Maximum value is 65535.
Specifies the port on which traffic will be monitored.
(Optional) Specifies the action of the filters on this channel as:
• matched ‐ Packets will be accepted on filter matches
• failed ‐ Packets will be accepted if they fail a match
(Optional) Enables or disables control of the flow of data through the
channel.
ge .2.12:
EntryStatus= valid
matched
0
ready