Show Port Duplex; Set Port Duplex - Enterasys D2 D2G124-12P Cli Reference Manual

D-series ethernet switches
Table of Contents

Advertisement

Example
This example shows how to set 
D2(su)->set port speed ge.3.3 10

show port duplex

Use this command to display the default duplex setting (half or full) for one or more ports.
Syntax
show port duplex [port-string]
Parameters
port‐string
Defaults
If port‐string is not specified, default duplex settings for all ports will be displayed.
Mode
Switch command, read‐only.
Example
This example shows how to display the default duplex setting for Gigabit Ethernet port 14 in 
slot 3:
D2(su)->show port duplex ge.3.14
default duplex mode is full on port ge.3.14.

set port duplex

Use this command to set the default duplex type for one or more ports. This command will only 
take effect on ports that have auto‐negotiation disabled.
Syntax
set port duplex port-string {full | half}
Parameters
port‐string
full | half
Defaults
None.
ge
.3.3 to a port speed of 10 Mbps:
(Optional) Displays default duplex setting(s) for specific port(s). 
For a detailed description of possible port‐string values, refer to 
"Port String Syntax Used in the CLI" on page 4‐1.
Specifies the port(s) for which duplex type will be set. For a detailed 
description of possible port‐string values, refer to "Port String Syntax 
Used in the CLI" on page 4‐1.
Sets the port(s) to full‐duplex or half‐duplex operation.
show port duplex
D-Series CLI Reference 4-11

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Enterasys d2 d2g124-12D2g124-12D2g124-12p

Table of Contents