Set Vlanauthorization - Enterasys D2 D2G124-12P Cli Reference Manual

Parameters
policy
tunnel
Defaults
Set to policy.
Mode
Switch command, read‐write.
Examples
This example shows how to set the policy maptable response to tunnel:
D2(rw)-> set policy maptable response tunnel

set vlanauthorization

Enable or disable the use of the RADIUS VLAN tunnel attribute to put a port into a particular
VLAN based on the result of authentication.
Syntax
set vlanauthorization {enable | disable} [port-string]
Parameters
enable | disable
port‐string
Defaults
VLAN authentication is disabled by default.
Mode
Switch command, read‐write.
Examples
This example shows how to enable VLAN authentication for all Gigabit Ethernet ports:
D2(rw)-> set vlanauthorization enable ge.*.*
This example shows how to disable VLAN authentication for all Gigabit Ethernet ports on switch
unit/module 3:
D2(rw)-> set vlanauthorization disable ge.3.*
Sets the maptable response to policy. This is the default setting, which
allows authentication of up to 8 multiauth users per port.
Sets the maptable response to tunnel, which allows authentication of up
to multiauth users per port. This setting is required to configure VLAN
authorization for multiple users per Gigabit port.
Enables or disables vlan authorization/tunnel attributes.
(Optional) Specifies which ports to enable or disable the use of VLAN
tunnel attributes/authorization. For a detailed description of possible port‐
string values, refer to "Port String Syntax Used in the CLI" on page 4‐1.
set vlanauthorization
D-Series CLI Reference 15-43