Set Linkflap Portstate; Set Linkflap Interval - Enterasys D2 D2G124-12P Cli Reference Manual

D-series ethernet switches
Table of Contents

Advertisement

set linkflap portstate

Mode
Switch mode, read‐write.
Usage
By default, the function is disabled globally and on all ports. If disabled globally after per‐port 
settings have been configured using the linkflap commands, per‐port settings will be retained.
Example
This example shows how to globally enable the link trap detection function.
D2(rw)->set linkflap globalstate enable
set linkflap portstate
Use this command to enable or disable link flap monitoring on one or more ports.
Syntax
set linkflap portstate {disable | enable} [port-string]
Parameters
disable | enable
port‐string
Defaults
If port‐string is not specified, all ports are enabled or disabled.
Mode
Switch command, read‐write.
Example
This example shows how to enable the link trap monitoring on all ports.
D2(rw)->set linkflap portstate enable

set linkflap interval

Use this command to set the time interval (in seconds) for accumulating link down transitions.
Syntax
set linkflap interval port-string interval-value
Parameters
port‐string
interval‐value
4-24 Port Configuration
Disables or enables the link flap detection function.
(Optional) Specifies the port or ports on which to disable or enable 
monitoring.
Specifies the port(s) on which to set the link flap interval. 
Specifies an interval in seconds. A value of 0 will set the interval to 
forever.

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Enterasys d2 d2g124-12D2g124-12D2g124-12p

Table of Contents