Show Ciscodp Port Info; Show Ciscodp Port Info Output Details - Enterasys D2 D2G124-12P Cli Reference Manual

show ciscodp port info

Table 3-9 show ciscodp Output Details (Continued)
Output Field
Timer
Holdtime
Device ID
Last Change
show ciscodp port info
Use this command to display summary information about the Cisco discovery protocol on one or
more ports.
Syntax
show ciscodp port info [port-string]
Parameters
port‐string
Defaults
If port‐string is not specified, Cisco DP information for all ports will be displayed.
Mode
Switch command, read‐only.
Example
This example shows how to display Cisco DP information for Gigabit Ethernet port 1 in slot 1.
D2(su)->show ciscodp port info ge.1.1
port
----------------------------------------------
ge.1.1
Table 3‐10 provides an explanation of the command output.
Table 3-10 show ciscodp port info Output Details
Output Field
Port
State
vvid
3-8 Discovery Protocol Configuration
What It Displays...
The number of seconds between Cisco discovery protocol PDU transmissions. The
default of 60 seconds can be reset with the set ciscodp timer command.
Number of seconds neighboring devices will hold PDU transmissions from the
sending device. Default value of 180 can be changed with the set ciscodp holdtime
command.
The MAC address of the switch.
The time that the last Cisco DP neighbor was discovered.
(Optional) Displays Cisco DP information for a specific port. For a detailed
description of possible port‐string values, refer to
the CLI
" on page 4‐1.
state vvid
enable none
What It Displays...
Port designation. For a detailed description of possible port-string values, refer to
"Port String Syntax Used in the
Whether Cisco DP is enabled, disabled or auto-enabled on the port. Default state of
enabled can be changed using the set ciscodp port command.
Whether a voice VLAN ID has been set on this port. Default of none can be changed
using the set ciscodp port command.
trusted cos
yes 0
CLI" on page 4-1.
"Port String Syntax Used in