Set Sntp Client; Clear Sntp Client - Enterasys D2 D2G124-12P Cli Reference Manual

set sntp client

Use this command to set the SNTP operation mode.
Syntax
set sntp client {broadcast | unicast | disable}
Parameters
broadcast
unicast
disable
Defaults
None.
Mode
Switch command, read‐write.
Example
This example shows how to enable SNTP in broadcast mode:
D2(su)->set sntp client broadcast

clear sntp client

Use this command to clear the SNTP client's operational mode.
Syntax
clear sntp client
Parameters
None.
Defaults
None.
Mode
Switch command, read‐write.
Example
This example shows how to clear the SNTP client's operational mode:
D2(su)->clear sntp client
Enables SNTP in broadcast client mode.
Enables SNTP in unicast (point‐to‐point) client mode. In this mode, the
client must supply the IP address from which to retrieve the current time.
Disables SNTP.
set sntp client
D-Series CLI Reference 12-27