Set Port Inlinepower; Downloading A Firmware Image - Enterasys D2 D2G124-12P Cli Reference Manual

Example
This example shows how to display PoE information for port
administrative state, PoE priority and class have not been changed from default values:
D2(su)->show port inlinepower ge.2.1
Port
----
ge.2.1

set port inlinepower

Use this command to configure PoE parameters on one or more ports.
Syntax
set port inlinepower port-string {[admin {off | auto}] [priority {critical | high
| low}] [type type]}
Parameters
port‐string
admin off | auto
priority critical |
high | low
type type
Defaults
None.
Mode
Switch command, read‐write.
Example
This example shows how to enable PoE on port
D2(su)->set port inlinepower ge.3.1 admin auto priority critical

Downloading a Firmware Image

You can upgrade the operational firmware in the D‐Series switch without physically opening the
switch or being in the same location. There are two ways to download firmware to the switch:
• Via TFTP download. This procedure uses a TFTP server connected to the network and
downloads the firmware using the TFTP protocol. For details on how to perform a TFTP
download using the copy command, refer to "copy" on page 2‐45. For information on setting
TFTP timeout and retry parameters, refer to "set tftp timeout" on page 2‐47 and "set tftp
retry" on page 2‐48.
• Via the serial (console) port. This procedure is an out‐of‐band operation that copies the
firmware through the serial port to the switch. It should be used in cases when you cannot
connect the switch to perform the in‐band copy download procedure via TFTP. Serial console
download has been successfully tested with the following applications:
Type Admin Oper
---- ----- ----
wireless auto searching
Specifies the port(s) on which to configure PoE.
Sets the PoE administrative state to off (disabled) or auto (on).
Sets the port(s) priority for the PoE allocation algorithm to critical
(highest), high or low.
Specifies a string describing the type of device connected to a port.
ge.2.1 . In this case, the port's
Priority Class
-------- -----
low 0
ge
.3.1 with critical priority:
set port inlinepower
Power(W)
--------
15.4
D-Series CLI Reference 2-33