Clear Nodealias Config - Enterasys D2 D2G124-12P Cli Reference Manual

Parameters
enable | disable
maxentries maxentries
port‐string
Defaults
None.
Mode
Switch command, read‐write.
Usage
Upon packet reception, node aliases are dynamically assigned to ports enabled with an alias
agent, which is the default setting on D‐Series devices. Node aliases cannot be statically created,
but can be deleted using the clear node alias command as described in "clear nodealias config" on
page 12‐33.
Example
This example shows how to disable the node alias agent on
D2(su)->set nodealias disable ge.1.3

clear nodealias config

Use this command to reset node alias state to enabled and clear the maximum entries value.
Syntax
clear nodealias config port-string
Parameters
port‐string
Defaults
None.
Mode
Switch command, read‐write.
Example
This example shows how to reset the node alias configuration on
D2(su)->clear nodealias config ge.1.3
Enables or disables a node alias agent.
Set the maximum number of alias entries per ports. Valid range is 0 to
4096. The default value is 32.
Specifies the port(s) on which to enable/disable node alias agent or set
a maximum number of entries.
Specifies the port(s) on which to reset the node alias configuration.
clear nodealias config
ge .1.3:
:
ge .1.3
D-Series CLI Reference 12-33