Show System; Show System Output Details - Enterasys D2 D2G124-12P Cli Reference Manual

show system

show system
Use this command to display system information, including contact information, power and fan
tray status and uptime.
Syntax
show system
Parameters
None.
Defaults
None.
Mode
Switch command, read‐only.
Example
This example shows how to display system information:
D2(su)->show system
System contact:
System location:
System name:
PWR1-A Status
----------
Ok
PWR2-A Status
----------
Not Installed and/or Not Operating Not Installed and/or Not Operating
Fan1-Status
-----------
Not Installed and/or Not Operating Not Installed and/or Not Operating
Uptime d,h:m:s
--------------
2,20:23:11
Table 2‐6 provides an explanation of the command output.
Table 2-6 show system Output Details
Output
System contact
System location
System name
PWR1-A Status
PWR1-B Status
PWR2-A Status
2-12 Basic Configuration
PWR1-B Status
----------
Not Installed and/or Not Operating
PWR2-B Status
----------
Fan2-Status
-----------
Logout
-------
30 min
What It Displays...
Contact person for the system. Default of a blank string can be changed with the
set system contact command
Where the system is located. Default of a blank string can be changed with the
set system location command
Name identifying the system. Default of a blank string can be changed with the
set system name command
Operational status for the power supply connected to PWR1-A on the switch.
Operational status for the power supply connected to PWR1-B on the switch.
Operational status for the power supply connected to PWR2-A on the switch.
("set system contact" on page 2-24).
("set system location" on page 2-23).
("set system name" on page 2-23).