Set Port Alias; Setting Speed And Duplex Mode; Purpose; Commands - Enterasys D2 D2G124-12P Cli Reference Manual

set port alias

Use this command to assign an alias name to a port.
Syntax
set port alias port-string [name]
Parameters
port‐string
name
Defaults
If name is not specified, the alias assigned to the port will be cleared.
Mode
Switch command, read‐write.
Examples
This example shows how to assign the alias "Admin" to
D2(rw)->set port alias ge.3.3 Admin
This example shows how to clear the alias for
D2(rw)->set port alias ge.3.3

Setting Speed and Duplex Mode

Purpose

To review and set the operational speed in Mbps and the default duplex mode: Half, for half
duplex, or Full, for full duplex for one or more ports.

Commands

For information about...
show port speed
set port speed
show port duplex
set port duplex
Specifies the port to which an alias will be assigned. For a detailed
description of possible port‐string values, refer to "Port String Syntax
Used in the CLI" on page 4‐1.
(Optional) Assigns an alias name to the port. If the alias name contains
spaces, the text string must be surrounded by double quotes. Maximum
length is 60 characters.
Note: These settings only take effect on ports that have auto-negotiation disabled.
ge .3.3:
ge .3.3:
set port alias
Refer to page...
4-10
4-10
4-11
4-14
D-Series CLI Reference 4-9