Configuring Simple Network Time Protocol (SNTP)
Purpose
To configure the Simple Network Time Protocol (SNTP), which synchronizes device clocks in a
network.
Commands
For information about...
show sntp
set sntp client
clear sntp client
set sntp server
clear sntp server
set sntp poll-interval
clear sntp poll-interval
set sntp poll-retry
clear sntp poll-retry
set sntp poll-timeout
clear sntp poll-timeout
show sntp
Use this command to display SNTP client settings.
Syntax
show sntp
Parameters
None.
Defaults
None.
Mode
Switch command, read‐only.
Note: A host IP address must be configured on the D2 to support SNTP.
Configuring Simple Network Time Protocol (SNTP)
Refer to page...
D-Series CLI Reference 12-25
12-25
12-27
12-27
12-28
12-28
12-29
12-29
12-29
12-30
12-30
12-31