hours
minutes
infinite
Defaults
If no lease time is specified, a lease duration of 1 day is configured.
Mode
Switch command, read‐write.
Example
This example configures a lease duration of 12 hours for the address pool being configured. Note
that to configure a lease time less than one day, enter 0 for days, then the number of hours and
minutes.
D2(rw)->set dhcp pool auto1 lease 0 12
clear dhcp pool lease
Use this command to restore the default lease time value of one day for the address pool being
configured.
Syntax
clear dhcp pool poolname lease
Parameters
poolname
Defaults
Clears the lease time for this address pool to the default value of one day.
Mode
Switch command, read‐write.
Example
This example restores the default lease duration of one day for address pool "auto1."
D2(rw)->clear dhcp pool auto1 lease
set dhcp pool default-router
Use this command to specify a default router list for the DHCP clients served by the address pool
being configured. Up to 8 default routers can be configured.
(Optional) When a days value has been assigned, specifies the number of
hours an address lease will remain valid. Value can range from 0 to 1439.
(Optional) When a days value and an hours value have been assigned,
specifies the number of minute an address lease will remain valid. Value
can range from 0 to 86399.
Specifies that the duration of the lease will be unlimited.
Specifies the name of the address pool. Pool names may be up to 31
characters in length.
clear dhcp pool lease
D-Series CLI Reference 14-21