Show Linkflap - Enterasys D2 D2G124-12P Cli Reference Manual

Parameters
port‐string
enable | disable
Defaults
Sending traps when link status changes is enabled by default.
Mode
Switch command, read‐write.
Example
The following example disables sending trap on ge.3.1.
D2(su)->set port trap ge.3.1 disable

show linkflap

Use this command to display link flap detection state and configuration information.
Syntax
show linkflap {globalstate | portstate | parameters | metrics | portsupported |
actsupported | maximum | downports | action | operstatus | threshold | interval]
| downtime | currentcount | totalcount | timelapsed | violations [port-string]}
Parameters
globalstate
portstate
parameters
metrics
portsupported
actsupported
maximum
downports
action
operstatus
threshold
interval
downtime
currentcount
Specifies the port(s) for which to enable or disable port traps. For a
detailed description of possible port‐string values, refer to "Port String
Syntax Used in the CLI" on page 4‐1.
Enables or disables sending trap messages when link status changes.
Displays the global enable state of link flap detection.
Displays the port enable state of link flap detection.
Displays the current value of settable link flap detection parameters.
Displays linkflap detection metrics.
Displays ports which can support the link flap detection function.
Displays link flap detection actions supported by system hardware.
Displays the maximum allowed linkdowns per 10 seconds supported
by system hardware.
Displays ports disabled by link flap detection due to a violation.
Displays linkflap actions taken on violating port(s).
Displays whether linkflap has deactivated port(s).
Displays the number of allowed link down transitions before action is
taken.
Displays the time period for counting link down transitions.
Displays how long violating port(s) are deactivated.
Displays how many linkdown transitions are in the current interval.
show linkflap
D-Series CLI Reference 4-21