Set Snmp User; Show Snmp User Output Details - Enterasys D2 D2G124-12P Cli Reference Manual

Examples
This example shows how to display an SNMP user list:
D2(su)->show snmp user list
--- SNMP user information ---
--- List of registered users:
Guest
admin1
admin2
netops
This example shows how to display information for the SNMP "guest" user:
(su)->show snmp user guest
--- SNMP user information ---
EngineId:
Username
Auth protocol
Privacy protocol
Storage type
Row status
Table 5‐20 provides an explanation of the command output.
Table 5-20 show snmp user Output Details
Output Field
EngineId
Username
Auth protocol
Privacy protocol
Storage type
Row status

set snmp user

Use this command to create a new SNMPv3 user.
Syntax
set snmp user user [remote remoteid] [authentication {md5 | sha}] [authpassword]
[privacy privpassword] [volatile | nonvolatile]
Parameters
user
remote remoteid
authentication md5
| sha
authpassword
privacy privpassword (Optional) Applies encryption and specifies an encryption password.
00:00:00:63:00:00:00:a1:00:00:00:00
= Guest
= usmNoAuthProtocol
= usmNoPrivProtocol
= nonVolatile
= active
What It Displays...
SNMP local engine identifier.
SNMPv1 or v2 community name or SNMPv3 user name.
Type of authentication protocol applied to this user.
Whether a privacy protocol is applied when authentication protocol is in
use.
Whether entry is stored in volatile, nonvolatile or read-only memory.
Status of this entry: active, notInService, or notReady.
Specifies a name for the SNMPv3 user.
(Optional) Registers the user on a specific remote SNMP engine.
(Optional) Specifies the authentication type required for this user as MD5
or SHA.
(Optional) Specifies a password for this user when authentication is
required. Minimum of 8 characters.
Minimum of 8 characters.
set snmp user
D-Series CLI Reference 5-9