Set Spantree Fwddelay; Clear Spantree Fwddelay - Enterasys D2 D2G124-12P Cli Reference Manual

D-series ethernet switches
Table of Contents

Advertisement

set spantree fwddelay

Example
This example shows how to globally reset the maximum aging time:
D2(su)->clear spantree maxage
set spantree fwddelay
Use this command to set the Spanning Tree forward delay. 
Syntax
set spantree fwddelay delay
Parameters
delay
Defaults
None.
Mode
Switch command, read‐write.
Usage
The forward delay is the maximum time (in seconds) the root device will wait before changing 
states (i.e., listening to learning to forwarding). This delay is required because every device must 
receive information about topology changes before it starts to forward frames. In addition, each 
port needs time to listen for conflicting information that would make it return to a blocking state; 
otherwise, temporary data loops might result.
Example
This example shows how to globally set the bridge forward delay to 16 seconds:
D2(su)->set spantree fwddelay 16

clear spantree fwddelay

Use this command to reset the Spanning Tree forward delay to the default setting of 15 seconds. 
Syntax
clear spantree fwddelay
Parameters
None.
Defaults
None.
6-20 Spanning Tree Configuration
Specifies the number of seconds for the bridge forward delay. Valid values 
are 4 ‐ 30.

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Enterasys d2 d2g124-12D2g124-12D2g124-12p

Table of Contents