clear port txq
Parameters
port‐string
value0 ‐ value7
Defaults
None.
Mode
Switch command, read‐write.
Usage
Queues can be set for strict priority (SP) or weighted round‐robin (WRR). If set for WRR mode,
weights may be assigned to those queues with this command. Weights are specified in the range
of 0 to 100 percent. Weights specified for queues 0 through 7 on any port must total 100 percent.
Examples
This example shows how to change the arbitration values for the eight transmit queues belonging
to
ge
.1.1:
D2(su)->set port txq ge.1.1 10 10 10 10 10 10 10 30
This example shows how to change the algorithm to strict priority for the eight transmit queues
belonging to
D2(su)->set port txq ge.1.1 0 0 0 0 0 O O 100
D2(su)->show port txq ge.1.1
Port
-----
ge.1.1
clear port txq
Use this command to clear port transmit queue values back to their default values.
Syntax
clear port txq port-string
10-8 Port Priority and Rate Limiting Configuration
Specifies port(s) on which to set queue arbitration values. For a detailed
description of possible port‐string values, refer to "Port String Syntax Used
in the CLI" on page 4‐1.
Only physical ports can be configured with this command. LAG ports
cannot be configured.
Specifies percentage to allocate to a specific transmit queue. The values
must total 100 percent.
ge
.1.1:
Alg
Q0
Q1
Q2
Q3
--- --- --- --- --- --- --- --- ---
STR SP
SP
SP
SP
Q4
Q5
Q6
Q7
SP
SP
SP
SP