Clear Rmon Alarm - Enterasys D2 D2G124-12P Cli Reference Manual

Parameters
index
enable
Defaults
None.
Mode
Switch command, read‐write.
Usage
An RMON alarm entry can be created using this command, configured using the set rmon alarm
properties command ("set rmon alarm properties" on page 13‐9), then enabled using this
command. An RMON alarm entry can be created and configured at the same time by specifying
an unused index with the set rmon alarm properties command.
Example
This example shows how to enable RMON alarm entry 3:
D2(rw)->set rmon alarm status 3 enable

clear rmon alarm

Use this command to delete an RMON alarm entry.
Syntax
clear rmon alarm index
Parameters
index
Defaults
None.
Mode
Switch command, read‐write.
Example
This example shows how to clear RMON alarm entry 1:
D2(rw)->clear rmon alarm 1
Specifies an index number for this entry. Maximum number or entries is
50. Maximum value is 65535.
Enables this alarm entry.
Specifies the index number of entry to be cleared.
clear rmon alarm
D-Series CLI Reference 13-11