Parameters
irl
all
group‐type‐index
irl‐index
unit
rate
type
Defaults
None.
Mode
Switch command, read‐write.
Example
This example clears the data rate to 0 for IRL resource index 1 for group 2.0.
D2(su)->clear cos port-resource irl 2.0 1 rate
set cos reference
Use this command to set the Class of Service inbound rate limiting reference configuration.
Syntax
set cos reference irl group-type-index reference rate-limit irl-index
Parameters
irl
group‐type‐index
reference
rate‐limit irl‐index
Defaults
None.
Specifies that an IRL resource is to be cleared.
Clear all IRL resources for all port groups.
Specifies an inbound rate limiting port group/type index. Valid entries are
in the form of group#.port‐type.
Valid values for group# can range from 0 to 7. Valid values for port‐type
can range from 0 to 1, although only port type 0 is currently supported.
For example, port group 3 would be specified as 3.0.
(Optional) Inbound rate limiter resource index associated with the
specified port group. Valid values range from 0 to 99.
Clear the unit of measure for the inbound rate limiter.
Clear the data rate for this inbound rate limiter.
Clear the action for the rate limiter.
Specifies that an IRL reference is being configured.
Specifies an inbound rate limiting port group/type index. Valid entries are
in the form of group#.port‐type.
Valid values for group# can range from 0 to 7. Valid values for port‐type
can range from 0 to 1, although only port type 0 is currently supported.
For example, port group 3 would be specified as 3.0.
IRL reference number associated with this entry.
Rate limiter (IRL resource index) to bind this reference to. Valid values
range from 0 to 99.
set cos reference
D-Series CLI Reference 9-27