Network Requirements; Smarttrunk Feature; 10Base-T Network - Enterasys Matrix 6H352-25 Installation Manual

Before installing the 6H352-25, review the requirements and specifications referred to in this
chapter concerning the following:
• SmartTrunk (Section
• 10BASE-T Twisted Pair Network
• 100BASE-T Twisted Pair Network
The network installation must meet the requirements to ensure satisfactory performance of this
equipment. Failure to do so will produce poor network performance.
NOTE: The Enterasys Networks MATRIX E7 Series and SmartSwitch 6000 Series
Modules Local Management User's Guide and Cabling Guide referred to in the following
sections can be found on the Enterasys Networks World Wide Web site:
http://www.enterasys.com/
2.1

SmartTrunk FEATURE

Before connecting the 6H352-25 to a network so it can take advantage of the SmartTrunk feature,
there are certain rules concerning port connections and configurations that must be followed for
proper operation. Refer to the SmartTrunk User's Guide for additional information.
2.2

10BASE-T NETWORK

When connecting a 10BASE-T segment to any of the 6H352-25 ports (1 through 24), ensure that
the network meets the Ethernet network requirements of the IEEE 802.3 standard for 10BASE-T.
Refer to the Cabling Guide for details.
NOTE: If a port is to operate at 100 Mbps, Category 5 cabling must be used.
Category 3 cabling does not meet 100 Mbps specifications. For 10 Mbps operation only,
Category 3 or Category 5 cabling can be used. Refer to
about 100BASE-TX networks and cabling.
2.1)
(Section
(Section

Network Requirements

2.2)
2.3)
Section 2.3 for information
Network Requirements
2
2-1