Mounting The Assembled Kit Into A Rack; Connecting Power, Console, And Network Cables; Rack Mount Switch Kit With Dual D2124-12Ps And Four D2-Poe-Pwrs - Enterasys D2G124-12 Hardware Installation Manual

Mounting the Assembled Kit Into a Rack

Note: The D2-PWR-POE is taller than one rack unit high. If you have installed one or more D2-
PWR-POE power supplies in the rack mount kit, ensure that your rack installation location leaves at
least one rack unit of free space above the mounted assembly kit.
Once the kit is fully assembled with one or more switches and power supplies, mount it to your
rack location as follows:
1. Ensure that you have appropriate screws for securing the assembled kit to your rack location.
These four screws are required and are not provided in the rack mount kit.
2. Using appropriate screws and the four screw holes in the corner edges of the rack mounting
tray, attach the assembled kit to your desired rack location. Tighten securely.
Figure 2-8

Rack Mount Switch Kit with Dual D2124-12Ps and Four D2-POE-PWRs

1 Power supply (D2-PWR-POEs shown)
2 D2 switch (Dual D2124-12Ps shown)

Connecting Power, Console, and Network Cables

Once the assembled rack mount kit is attached to your rack location, proceed to:
• Connect power to the switch(es) by plugging each AC power cord into a dedicated, grounded
AC outlet. Refer to "Connecting Power to the Switch" on page 2‐26.
• Attach console cable(s). Refer to "Connecting to the Console Port" on page 2‐27 for more
information.
• Attach network cables. Refer to "Connecting to the Network" on page 2‐28 for more
information.
3 PWR1-B and PWR2-B PoE DC power receptacles
4 DC power chords
Enterasys D-Series Hardware Installation Guide 2-9
Mounting the Switch