Mld Snooping Querier Configuration - NETGEAR GSM7252PS - ProSafe 52 Ports Gigabit Ethernet L2 Managed Stackable Switch User Manual

ProSafe® Gigabit L3 Managed Stackable Switches Software Administration Manual

MLD Snooping Querier Configuration

Use this menu to configure the parameters for MLD Snooping Querier. Note that only a user
with Read/Write access privileges may change the data on this screen.
To access the MLD Snooping Querier Configuration page, click Switching

Snooping Querier Configuration.
1. Use Querier Admin Mode to select the administrative mode for MLD Snooping for the
switch. The default is disable.
2. Use Querier Address to specify the Snooping Querier Address to be used as source
address in periodic MLD queries. This address is used when no address is configured on
the VLAN on which query is being sent. The supported IPv6 formats are x:x:x:x:x:x:x:x and
x::x.
3. Use MLD Version to specify the MLD protocol version used in periodic MLD queries. MLD
queries.
4. Use Query Interval(secs) to specify the time interval in seconds between periodic queries
sent by the snooping querier. The Query Interval must be a value in the range of 1 and
1800. The default value is 60.
5. Use Querier Expiry Interval(secs) to specify the time interval in seconds after which the
last querier information is removed. The Querier Expiry Interval must be a value in the range
of 60 and 300. The default value is 60.
Table 3-67.
Field
VLAN Ids Enabled For MLD Snooping Querier
190 | Chapter 3. Configuring Switching Information
Description
Displays VLAN Ids enabled for MLD snooping
querier.
 
Multicast MLD