Mld Snooping Interface Configuration - NETGEAR GSM7252PS - ProSafe 52 Ports Gigabit Ethernet L2 Managed Stackable Switch User Manual

ProSafe® Gigabit L3 Managed Stackable Switches Software Administration Manual

MLD Snooping Interface Configuration

To access the MLD Snooping Interface Configuration page, click Switching

MLD Snooping Interface Configuration.
1. Interface - Displays all physical, VLAN, and LAG interfaces. Select the interface you
want to configure.
2. Use Admin Mode to select the interface mode for the selected interface for MLD Snooping
for the switch. The default is disable.
3. Use Group Membership Interval(secs) to specify the amount of time you want the switch
to wait for a report for a particular group on a particular interface before it deletes that
interface from the group. The valid range is from (2 to 3600) seconds. The configured value
must be greater than Max Response Time. The default is 260 seconds.
4. Use Max Response Time(secs) to specify the amount of time you want the switch to wait
after sending a query on an interface because it did not receive a report for a particular
group on that interface. Enter a value greater or equal to 1 and less than the Group
Membership Interval in seconds. The default is 10 seconds. The configured value must be
less than the Group Membership Interval.
5. Use Present Expiration Time to specify the amount of time you want the switch to wait to
receive a query on an interface before removing it from the list of interfaces with multicast
routers attached. Enter a value between 0 and 3600 seconds. The default is 0 seconds. A
value of zero indicates an infinite time-out, i.e. no expiration.
6. Use Fast Leave Admin mode to select the Fast Leave mode for the a particular interface
from the pull-down menu. The default is disable.
186 | Chapter 3. Configuring Switching Information
 
Multicast