NETGEAR GSM7252PS - ProSafe 52 Ports Gigabit Ethernet L2 Managed Stackable Switch User Manual page 360

ProSafe® Gigabit L3 Managed Stackable Switches Software Administration Manual
PIM-DM Interface Configuration
To display the PIM-DM Interface Configuration page, click Routing
Interface Configuration.
1. Interface - The interface for which data is to be displayed or configured. You must have
configured at least one router interface before configuring or displaying data for a
PIM-DM interface.
2. Use Admin Mode to set the administrative status of PIM-DM for the selected interface. The
default is disable.
3. Use Hello Interval to enter the number of seconds between PIM hello messages
transmitted from the selected interface. The default value is 30. Valid values are from 10 to
3600.
Table 65.
Field
Protocol State
IP Address
Neighbor Count
Designated Router
360 | Chapter 4. Routing
Description
The operational state of the PIM-DM protocol on this
interface.
The IP address of the selected interface.
The number of PIM neighbors on the selected
interface.
The designated router on the selected PIM interface.
For point-to-point interfaces, this will be 0.0.0.0.
  
Multicast PIM-DM