NETGEAR GSM7252PS - ProSafe 52 Ports Gigabit Ethernet L2 Managed Stackable Switch User Manual page 534

ProSafe® Gigabit L3 Managed Stackable Switches Software Administration Manual
• Assign Queue ID - Specifies the hardware egress queue identifier used to handle all
packets matching this ACL rule. Enter an identifying number from 0–6 in the
appropriate field.
• Match Every - Select true or false from the pull-down menu. True signifies that all
packets will match the selected IP ACL and Rule and will be either permitted or
denied. In this case, since all packets match the rule, the option of configuring other
match criteria will not be offered. To configure specific match criteria for the rule,
remove the rule and re-create it, or re-configure 'Match Every' to 'False' for the other
match criteria to be visible.
• Mirror Interface - Specifies the specific egress interface where the matching traffic
stream is copied in addition to being forwarded normally by the device. This field
cannot be set if a Redirect Interface is already configured for the ACL rule. This field
is visible for a 'Permit' Action.
• Redirect Interface - Specifies the specific egress interface where the matching traffic
stream is forced, bypassing any forwarding decision normally performed by the
device. This field cannot be set if a Mirror Interface is already configured for the ACL
rule. This field is visible for a 'Permit' Action.
• Source IP Address - Requires a packet's source IP address to match the address
listed here. Type an IP Address in the appropriate field using dotted-decimal notation.
The address you enter is compared to a packet's source IP Address.
• Source IP Mask - Specify the IP Mask in dotted-decimal notation to be used with the
Source IP Address value.
2. To delete an IP ACL rule, select the check box associated with the rule, and then click
Delete.
3. To update an IP ACL rule, select the check box associated with the rule, update the desired
fields, and then click Apply. You cannot modify the Rule ID of an existing IP rule.
4. Click Cancel to cancel the configuration on the screen and reset the data on the screen to
the latest value of the switch.
5. If you change any of the settings on the page, click Apply to send the updated configuration
to the switch. Configuration changes take effect immediately.
534 | Chapter 6. Managing Device Security