Advanced - NETGEAR GSM7252PS - ProSafe 52 Ports Gigabit Ethernet L2 Managed Stackable Switch User Manual

ProSafe® Gigabit L3 Managed Stackable Switches Software Administration Manual

Advanced

From the Advanced link, you can access the following pages:
• VRRP Configuration
• VRRP Secondary IP
• Tracking Configuration
• Virtual Router Statistics
VRRP Configuration
Use the VRRP Configuration page to enable or disable the administrative status of a virtual
router.
To display the VRRP Configuration page, click Routing
Configuration.
Global Configuration
1. Use Admin Mode to set the administrative status of VRRP in the router to active or
inactive. Select enable or disable from the radio button. The default is disable.
2. VRID is only configurable if you are creating new Virtual Router, in which case enter the
VRID in the range 1 to 255.
3. Use Interface to select the Unit/Slot/Port for the new Virtual Router from the pull-down
menu.
4. Use Pre-empt Mode to select enable or disable. If you select enable, a backup router will
preempt the master router if it has a priority greater than the master virtual router's priority
provided the master is not the owner of the virtual router IP address. The default is enable.
5. Use Priority to enter the priority value to be used by the VRRP router in the election for the
master virtual router. If the Virtual IP Address is the same as the interface IP Address, the
priority gets set to 255 no matter what the user enters. If the user enters a priority of 255
when the Virtual and interface IP Addresses are not the same, the priority gets set to the
default value of 100.
6. Use Advertisement Interval to enter the time, in seconds, between the transmission of
advertisement packets by this virtual router. Enter a number between 1 and 255. The default
value is 1 second.
on page 329
on page 331
on page 332
on page 333
  
VRRP Advanced
Chapter 4. Routing
VRRP
| 329