ProSafe® Gigabit L3 Managed Stackable Switches Software Administration Manual
Table 5.
Field
Status
Fault Status
SNMP
From SNMP link under the System tab, you can configure SNMP settings for SNMP V1/V2
and SNMPv3.
From the SNMP link, you can access the following pages:
•
SNMPV1/V2
on page 93
•
SNMP V3
on page 101
SNMPV1/V2
The pages under the SNMPV1/V2 menu allow you to configure SNMP community
information, traps, and trap flags.
From the SNMP V1/V2 link, you can access the following pages:
•
Community Configuration
•
Trap Configuration
•
Trap Flags
on page 97
•
Supported MIBs
on page 94
on page 96
on page 99
Definition
Operational status of the port PD detection.
•
Disabled - indicates no power being delivered.
•
DeliveringPower - indicates power is being drawn
by device.
•
Fault - indicates a problem with the port.
•
Test - indicates port is in test mode.
•
otherFault - indicates port is idle due to error
condition.
•
Searching - indicates port is not in one of the
above states.
Describes the error description when the PSE port is
in fault status. "No Error" value specifies that the
PSE port is not in any error state. "MPS Absent"
value specifies that the PSE port has detected an
absence of main power supply. "Short" value
specifies that the PSE port has detected a short
circuit condition. "Overload" value specifies that the
pd connected to the PSE port had tried to provide
more power than it is permissible by the hardware.
"Power Denied" value specifies that the PSE port
has been denied power because of shortage of
power or due to administrative action.
Chapter 2. Configuring System Information
| 93