ProSafe® Gigabit L3 Managed Stackable Switches Software Administration Manual
1.
Interface - The interface for which data is to be configured or to be displayed.
2.
Use Admin Mode to set the administrative status of PIM-SM in the router. The default is
disable.
3.
Use Hello Interval(secs) to enter the time in seconds between the transmission of which
PIM Hello messages on this interface. The valid values are from 0 to 18000. The default
value is 30.
4.
Use Join/Prune Interval(secs) to enter the frequency at which PIM Join/Prune messages
are transmitted on this PIM interface. The valid values are from 0 to 18000. The default
value is 60.
5.
Use BSR Border to set BSR border status on the selected interface.
6.
Use DR Priority to enter the DR priority for the selected interface. The valid values are from
0 to 2147483647. The default value is 1.
Table 67.
Field
Protocol State
IP Address
Designated Router
Neighbor Count
Description
The state of PIM-SM in the router: either operational
or non-operational.
The IPv4 address of the selected PIM interface.
The Designated Router on the selected PIM
interface.
The number of PIM neighbors on the selected
interface.
Chapter 4. Routing
| 365