Igmp Snooping Querier Vlan Configuration - NETGEAR GS716T Software Administration Manual

1. From the Querier Admin Mode field, enable or disable the administrative mode for
IGMP Snooping Querier.
2. In the Snooping Querier Address field, specify the IP address to be used as source
address in periodic IGMP queries. This address is used when no address is configured on
the VLAN on which the query is being sent.
3. In the IGMP Version field, specify the IGMP protocol version used in periodic IGMP queries.
4. In the Query Interval field, specify the time interval in seconds between periodic queries
sent by the snooping querier. The Query Interval must be a value in the range of 1–1800
seconds. The default value is 60.
5. In the Querier Expiry Interval field, specify the time interval in seconds after which the last
querier information is removed. The Querier Expiry Interval must be a value in the range of
60–300 seconds. The default value is 60.
6. Click Cancel to cancel the configuration on the screen and reset the data on the screen to
the latest value of the switch.
7. Click Apply to apply the new settings to the switch. Configuration changes take effect
immediately
8. Click Refresh to update the page with the latest information from the switch.

IGMP Snooping Querier VLAN Configuration

Use this page to configure IGMP queriers for use with VLANs on the network.
To access this page, click Switching Multicast  IGMP Snooping Querier  Querier VLAN
Configuration.
To configure Querier VLAN settings:
1. To create a new VLAN ID for IGMP Snooping, select New Entry from the VLAN ID field
and complete the following fields:
• VLAN ID. Specifies the VLAN ID for which the IGMP Snooping Querier is to be
enabled.
• Querier Election Participate Mode. Enable or disable Querier Participate Mode.
120 | Chapter 3: Configuring Switching Information
GS716Tv2 and GS724Tv3 Software Administration Manual