Ip Subnet Based Vlan - NETGEAR GSM7252PS - ProSafe 52 Ports Gigabit Ethernet L2 Managed Stackable Switch User Manual

ProSafe® Gigabit L3 Managed Stackable Switches Software Administration Manual

IP Subnet Based VLAN

IP Subnet to VLAN mapping is defined by configuring an entry in the IP Subnet to VLAN
table. An entry is specified via a source IP address, network mask, and the desired VLAN ID.
The IP Subnet to VLAN configurations are shared across all ports of the device.
To display the MAC Based VLAN page, click Switching
Based VLAN.
1. Use IP Address to specify a valid IP Address bound to VLAN ID. Enter the IP Address
in dotted decimal notation.
2. Use Subnet Mask to specify a valid Subnet Mask of the IP Address. Enter the Subnet mask
in dotted decimal notation.
3. Use VLAN ID to specify a VLAN ID in the range of (1 to 4093).
4. Click ADD to add a new IP subnet-based VLAN.
5. Click DELETE to delete the IP subnet-based VLAN selected.
142 | Chapter 3. Configuring Switching Information
  
VLAN Advanced IP Subnet