Factory Default - NETGEAR GSM7252PS - ProSafe 52 Ports Gigabit Ethernet L2 Managed Stackable Switch User Manual

ProSafe® Gigabit L3 Managed Stackable Switches Software Administration Manual

Factory Default

Use the Factory Default page to reset the system configuration to the factory default values.
Note: If you reset the switch to the default configuration, the IP address is
reset to 169.254.100.100, and the DHCP client is enabled. If you
lose network connectivity after you reset the switch to the factory
defaults, see
To access the Factory Defaults page, click Maintenance
To reset the switch to the factory default settings:
1. Select the check box and click the APPLY button to have all configuration parameters
reset to their factory default values. All changes you have made will be lost, even if you
have issued a save. You will be shown a confirmation screen after you select the button.
582 | Chapter 8. Maintenance
Web Access on page 9.
 
Reset Factory Default.