Radius Server Configuration - NETGEAR GSM7252PS - ProSafe 52 Ports Gigabit Ethernet L2 Managed Stackable Switch User Manual

ProSafe® Gigabit L3 Managed Stackable Switches Software Administration Manual

RADIUS Server Configuration

Use the RADIUS Server Configuration page to view and configure various settings for the
current RADIUS server configured on the system.
To access the RADIUS Server Configuration page, click Security

RADIUS Server Configuration link.
To configure a RADIUS server:
1. To add a RADIUS server, specify the settings the following list describes, and click Add.
• In the Radius Server IP Address field, specify the IP address of the RADIUS server
to add.
• In the Radius Server Name field, specify the Name of the server being added.
• Use Port to specify the UDP port used by this server. The valid range is 0 - 65535.
• Secret Configured - The Secret will only be applied if this option is "yes". If the option
is "no", anything entered in the Secret field will have no affect and will not be retained.
• Use Secret to specify the shared secret for this server.
• Use Primary Server
• Use Message Authenticator to enable or disable the message authenticator attribute
for the selected server.
2. Click ADD to add a new server to the switch. This button is only available to READWRITE
users. These changes will not be retained across a power cycle unless a save is performed.
3. Click DELETE to remove the selected server from the configuration. This button is only
available to READWRITE users. These changes will not be retained across a power cycle
unless a save is performed.
Table 6-82.
Field
Current
to set the selected server to the Primary or Secondary server.
Description
Indicates if this server is currently in use as the
authentication server.
Chapter 6. Managing Device Security

Management Security>
| 435