config.security.authentication.interface.nport.sequence
Syntax
Purpose
Parameters
Command Example
config.security.authentication.interface.osms.outgoing
Syntax
Purpose
sequence
method1
This command sets the sequence that the N_Port interface will use to
authenticate. When the preferred method cannot be contacted, the
backup method will be used to authenticate the remote end of the
ISL.
NOTE: This command requires that the SANtegrity Authentication feature
key be installed.
This command has one required parameter, and one optional
parameter:
method1
This sets the preferred method of
authentication. Accepted values are local or
RADIUS.
This optional parameter sets the backup
method2
method of authentication. This backup
method is used when the preferred method
cannot be contacted. Accepted value is local.
NOTE: A preferred method of local and a backup method of RADIUS is not
an accepted combination because the local method can always be contacted.
Root> config security authentication interface nport
sequence RADIUS local
outgoing
enabledState
This command determines if outgoing authentication is used on all
OSMS requests. The OSMS key must be configured prior to setting
the outgoing state to enabled.
[method2]
config
CLI Commands
2-39
2