Config.security.switchacl.deleterange; Config.security.switchacl.setstate; Config.security.switchacl.show - McDATA 316095-B21 - StorageWorks Edge Switch 2/24 User Manual

config.security.switchAcl.deleteRange

Syntax
Purpose
Parameters
Command Example

config.security.switchAcl.setState

Syntax
Purpose
Parameters
Command Example

config.security.switchAcl.show

Syntax
deleteRange startIPAddress endIPAddress
This command deletes a range of IP addresses from the access control
list. This range must exactly match one of the existing ranges in the
access control list.
This command has the following parameters:
startIPAddress The starting IP Address of the range to be
deleted. The address must be entered in dotted
decimal form (such as, 10.0.0.0).
clear - Using the optional 'clear' parameter by
itself will remove all entries from the access
control list.
endIPAddress The ending IP Address of the range to be
deleted. The address must be entered in dotted
decimal form (such as, 10.0.0.0).
Root> config security switchAcl deleteRange 10.0.0.0
10.0.0.2
setState aclEnabledState
This command enables or disables access control list.
This command has one parameter:
aclEnabledState This parameter can be set to enable or disable.
Boolean 1 and 0 values may also be substituted.
Root> config security switchAcl setState 1
show
config
CLI Commands
2-65
2