Show.thresholdalerts.log - McDATA 316095-B21 - StorageWorks Edge Switch 2/24 User Manual

Safety #2
Safety #1

show.thresholdAlerts.log

Syntax
Purpose
Parameters
Command Example
Output
Logic Lnk Err Set
Cls2 BusiedFrms
log [clear]
This command shows the contents of the threshold alert log. This log
shows all the threshold alerts that have been triggered, including
both counter threshold alerts (CTAs) and throughput threshold alerts
(TTAs).
ATTENTION! If the switch is restarted (as occurs during IPL, IML,
configuration reset, feature key installation, or firmware load) or is power
cycled, the information in the threshold alert log is lost.
This command has one parameter:
This optional parameter causes all threshold log
clear
entries to be cleared.
Root> show thresholdAlerts log
The threshold alert log data appears as a table that includes the
following properties:
Date/Time The date and time of the alert.
Name The name of the threshold alert, truncated to 22
characters.
Port The type of threshold alert (CTAs only).
Type The trigger statistic or threshold type of the alert
(abbreviated to 17 characters). These include:
Tx Util
Rx Util
Tx/Rx Util
Link Resets Sent
Enabled
Disabled
TTA - Transmit Utilization.
TTA - Receive Utilization.
TTA - Transmit or Receive
Utilization.
CTA - Link Resets Sent.
CLI Commands
show
2
2-237