Show.port.nodes - McDATA 316095-B21 - StorageWorks Edge Switch 2/24 User Manual

Output
Output Example

show.port.nodes

Syntax
Purpose
The port information data is displayed as a table that includes the
following properties:
Port The port number.
WWN The WWN of the port.
OpSpeed The current operating speed (1 Gb/s, 2 Gb/s, 4
Gb/s, or Not Established).
SpeedCap The current transceiver capability speed
(1 Gb/s, 2 Gb/s, or 4 Gb/s).
The output from the show.port.info command appears as follows:
Port WWN
---- -----------------------
0 10:00:80:00:11:22:33:44
1 10:00:80:01:11:22:33:44
2 10:00:80:02:11:22:33:44
3 10:00:80:03:11:22:33:44
4 10:00:80:04:11:22:33:44
5 10:00:80:05:11:22:33:44
6 10:00:80:06:11:22:33:44
7 10:00:80:07:11:22:33:44
8 10:00:80:08:11:22:33:44
9 10:00:80:09:11:22:33:44
10 10:00:80:10:11:22:33:44
11 10:00:80:11:11:22:33:44
12 10:00:80:12:11:22:33:44
13 10:00:80:13:11:22:33:44
14 10:00:80:14:11:22:33:44
15 10:00:80:15:11:22:33:44
nodes portNumber
This command displays the loginserver entries for a specified port.
This command is valid only on the Sphereon 4300 and Sphereon 4500
switches.
OpSpeed SpeedCap
-------- --------
1 Gb/sec 2 Gb/sec
1 Gb/sec 2 Gb/sec
1 Gb/sec 2 Gb/sec
1 Gb/sec 2 Gb/sec
2 Gb/sec 2 Gb/sec
2 Gb/sec 2 Gb/sec
2 Gb/sec 2 Gb/sec
2 Gb/sec 2 Gb/sec
2 Gb/sec 2 Gb/sec
2 Gb/sec 2 Gb/sec
1 Gb/sec 2 Gb/sec
1 Gb/sec 2 Gb/sec
1 Gb/sec 2 Gb/sec
1 Gb/sec 2 Gb/sec
1 Gb/sec 2 Gb/sec
1 Gb/sec 2 Gb/sec
CLI Commands
show
2
2-201