config.openSysMS.setHostCtrlState
Syntax
Purpose
Parameters
Command Example
config.openSysMS.setState
Syntax
Purpose
Parameters
Command Example
6
130
...
NOTE: The command
show.NPIV.config
is the same as this command.
setHostCtrlState HostContrlState
This command enables or disables Open Systems Management
Server (OSMS) Host Control.
This command has one parameter:
HostContrlState
This parameter can be set to enable or disable.
Boolean 1 and 0 values may also be
substituted.
Root> config openSysMS setHostCtrlState enable
setState osmsState
This command enables or disables Open Systems Management
Server (OSMS) feature. OSMS is a feature that allows host control and
inband management of the switch or director through a management
application that resides on an open-systems interconnection (OSI)
device.
This command has one parameter.
osmsState
Specifies whether the Open Systems
Management Server is enabled. Valid values are
enable and disable. Boolean 1 and 0 may be
substituted as values.
Root> config openSysMS setState 1
on page 2-193 has functionality that
CLI Commands
config
2
2-25