show
show.all
Syntax
Purpose
Parameters
Command Example
Output
The show branch of the CLI command tree contains commands that
display, but do not change, stored data values. The displayed output
that results from these commands is not necessarily identical with the
output from the show commands that are within the other CLI
command tree branches, for example, config.port.show.
The commands in the show branch can by used by either the
administrator or the operator.
all
This command displays all configuration and status information that
are available. The command results in a sequential display of the
output of other CLI show commands. This set of show commands
returns the full configuration and status of the switch and fabric.
This command has no parameters.
Root> show all
The output of this command is a sequential display of the output of
other CLI show commands. The commands are displayed in the
following order:
•
show.ip.ethernet
•
show.system
•
show.switch
•
show.port.config
•
show.frus
•
config.snmp.show
•
show.zoning
•
show.port.state
•
show.port.info
•
show.port.technology
•
show.loginserver
show
CLI Commands
2-167
2