McDATA 316095-B21 - StorageWorks Edge Switch 2/24 User Manual page 261

The output from the show.preferredPath.showPath command includes
Output
the following parameters:
The following examples show the output returned by the three
Command and
Output Examples methods of specifying the show.preferredPath.showPath command.
Single values for both parameters
Root> show preferredPath showPath 21 10
Preferred Path State: Enabled
Preferred Exit Port:
Actual Exit Port:
destDomainId set to all
Root> show preferredPath showPath all 15
Preferred Path State: Enabled
Destination Domain
------------------
1
3
4
17
Destination The destination domain ID to which a preferred
Domain path has been configured. This is displayed
only if the destination domain parameter is set
to all.
Source Port The source port for which a preferred path to
the specified destination domain ID is specified.
This is displayed only if the source port
parameter is set to all.
Preferred Exit The configured preferred path exit port. This
Port value can be any port number, or blank to
indicate that no preferred path has been
configured.
Actual Exit Port This is the actual exit port being used for the
given path.
Not Configured
45
Preferred Exit Port
-------------------
23
24
23
12
show
Actual Exit Port
----------------
23
No Path
23
No Source
CLI Commands
2-217
2