Config.security.switchacl; Config.security.switchacl.addrange - McDATA 316095-B21 - StorageWorks Edge Switch 2/24 User Manual

config
2
Output Example

config.security.switchAcl

config.security.switchAcl.addRange

Command Example
E/OS Command Line Interface User Manual
2-64
The output of the config.security.ssh.show command displays the
Output
following data:
SSH
Telnet
SSH:
Telnet:
The access control list (ACL) feature allows the administrator to
configure a set of IP addresses that are allowed to make an IP
management connection to the switch or director.
Syntax
addRange startIPAddress endIPAddress
This command adds a new range of IP addresses to the access control
Purpose
list.
This command has the following parameters:
Parameters
startIPAddress
endIPAddress
NOTE: The maximum number of entries in this command is 32.
Root> config security switchAcl addRange 10.0.0.0
10.0.0.2
Indicates whether the SSH interface to CLI is
enabled or disabled.
Indicates whether the Telnet interface to CLI
is enabled or disabled.
enabled
disabled
The starting IP Address of the range to be
added. The address must be entered in dotted
decimal form (such as, 10.0.0.0).
The ending IP Address of the range to be
added. The address must be entered in dotted
decimal form (such as, 10.0.0.0).