McDATA 316095-B21 - StorageWorks Edge Switch 2/24 User Manual page 60

config
2
Command Example
Output Example
Name
-----------------------------------------------------
Default Protocol Error Policy
Policy_1
E/OS Command Line Interface User Manual
2-16
When no parameters are specified, the command will display the
name, type, and state of all policies. If the optional parameter is
specified, it will display all the information about the policy.
NOTE: If the name parameter is not supplied, then only 50 characters of the
policy name will be displayed. In such cases enable the Comma Delimited
Mode to view the full name.
Root> config fencing show
Root> config fencing show Policy_1
If you do not specify the name parameter, then the output shows the
Output
following information:
Name
Ports
Type
Limit
Period
State
The output from the config.fencing.show command appears follows:
Type
Protocol Error
Protocol Error
The output from the config.fencing.show Policy_1 command appears as
follows:
Name:
Ports:
Type:
Limit:
The name of the policy. This will be
concatenated to 50 characters in the summary
display. You can view the policy full name in
the comma delim mode.
The ports to which the fencing policy will be
applied.
The type of the fencing policy.
The number of offenses that are allowed
before a port is disabled.
The amount of time that limit of number of
offenses must exceed before a port is fenced.
The enabled state of the fencing policy.
State
Disabled
Disabled
Policy_1
E ports
Protocol Error
5